Power UNITS FOR LIFT TABLE one
Standard Description
This power unit is developed exclusively for your compact lift table,Consisting of high stress gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This power unit has been broadly utilised from the marketplace of logistic units for instance minifork lift, scissors lift and ariel functioning platforms. The lower-ing movement is managed by the solenoid valve using the pace managed through the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE two
General Description
This energy unit is developed solely to the medium lift table, Consisting of hugely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve as well as speed managed through the adjustable needle valve. Once the lift rises to a higher positoin, however the power supply is minimize, the reducing motion is controlled from the manual override perform.
Electrical power UNITS FOR LIFT TABLE three
General Description
This electrical power unit is created solely for your large lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve and also the speed controlled by a strain compensated movement control valve.
Power UNITS FOR LIFT TABLE four
General Description
This power unit is created exclusively for that large lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived from the solenoid valve plus the velocity controlled through the adjustable needle valve. Once the lift rises to a substantial positoin, but the power supply is minimize, the reducing motion is managed by the guide override perform.
Particular Notes
one. This power unit is of S3 duty cycle, which may only function intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean every one of the hydraulic elements concerned before installation of the energy unit.
3. Viscosity in the oil shoud be 15~46 cst,which should also be clean and cost-free of impurities.N46 hydraulic oil is proposed.
4. Oil transforming is required just after the preliminary 100 operation hours,afterwards once each 3000 hours.
5. The energy unit proven is made to be mounted vertically.