Consisting of a stress balanced gear pump, DC motor, multi-functional manifold, valves, tank, ect., this electrical power unit is created to operate materials managing products. The reducing motion is achived by the solenoid valve with the decreasing velocity controlled by an adjustable needle valve. The left and appropriate functions are equipped by using a dual pilot operated check valve and cross-over relief valves.
Remark: Please seek advice from our income engineer for your diverse pump displacement, motor energy or tank capability.
1. This electrical power unit is of S3 duty cycle, i.e.,non-continuous operation,thirty seconds on and 270 seconds off.
2. Clean the many hydraulic components concerned just before set up of the electrical power unit.
three. Viscosity of the hydraulic oil shoud be 15~46 cst, which need to also be clean and free of charge of impurities.N46 hydraulic oil is recommended.
4. This electrical power unit need to be mounted horizontal.
5. Check the oil level in the tank immediately after the primary start out on the electrical power unit.
6. Oil modifying is needed after the first one hundred operation hrs, afterwards after every single 3000 hrs.